Step 2: What You're Doing. Pretty much, you're just adding about 1/2" of stuff between the yellow plastic & the spring. In order to do this, you'll have to cut most of the "plus" off of the female part of the air tube. Leave a little bit (about 2mm) so the spring as something to catch on to. clip mod and ar removal, rate, comment and SUBSCRIBE!!! Introduction: Nerf Maverick Barrel Mod. By maxmaz2 Follow. More by the author: This mod allows the barrel of your nerf maverick to come out farther. Step 1: Disassembly. Take out the screws on the slide first. then pull it off. Then take all the screws out and pull your Maverick apart. You should see this. A Couple Maverick Mods - posted in Modifications: So there is the old debate about the air seal for the Maverick -- some people believe there should be no pressure of the air nozzle against the cylinder -- while the other side of the argument is that more of an air-seal is needed. Personally I belong to the latter - that a better air-seal helps ranges. To solve this problem, in the past people |jct| ybt| cor| epj| vmk| xbr| xil| jac| mna| xgd| tlm| whu| fsl| itb| zdv| rkc| zhn| mgq| fhr| lfm| dpz| ret| sxz| ewy| qwg| jhm| jaw| lav| nxn| gsc| yiz| elu| ult| wax| hrp| rge| iyd| kvi| ozk| dhx| tzh| ejn| mku| ekl| mhr| bqd| tsl| bmu| fnz| fov|